VoLTE: PDN connectivity request vs handover

The PDN connectivity procedure is to request the setup of a default EPS bearer  to a PDN[TS24.301]. The PDN can either be the default PDN or an additional PDN. When it is the default PDN, the UE establishes the default EPS bearer as a part of the process of initial attach. If it is a subsequent PDN, this procedure will establish additional default EPS bearer with that PDN. As such the UE supports multiple default EPS bearers in multiple PDNs.

When the PDN connectivity procedure does collide with the handover procedure, the EPS shall be able to handle the situation based on the principle of best effort. The MME may pause the bearer creation procedure and resume when the handover is completed or the MME shall reattempt the E-RAB setup request after the handover is completed[TS23.401].

The following is the case where the PDN connectivity procedure collides with the X2 handover.

The above is the case the PDN connectivity request is sent for the second PDN. In this example, the MME proceeds the activation of the default EPS bearer by sending the Activate default EPS bearer Context request over S1AP while the X2 handover is in progress at the eNB. The eNB rejects the E-RAB Setup request with its cause value set to "X2-handover-triggered". Upon receiving the rejection to the E-RAB Setup request, the MME shall wait until the X2 handover is completed. Once it is completed, the MME re-attempts the activation of the default EPS bearer request. The following shows the S1AP procedure where the E-RAB setup request is rejected while subsequent PDN connectivity procedure.

The same mechanism is also applied to the S1 handover case as shown below.

In this case, the MME requests activation of the default EPS bearer as a normal procedure before receiving the Handover Required while the eNB already sent the Handover Required and subsequently receives the Activate default EPS bearer Context request. If the handover is only in preparation stage, the eNB may be able to cancel the handover and continues the E-RAB setup procedure. Instead, in this example, the eNB rejects the E-RAB setup request with its cause value set to "S1 intra system handover triggered". Upon rejection, the MME hold the state until the S1 handover is completed and resumes by reattempting the activation of the default EPS bearer.

NOTE the MME may pause between the step #b and the setp #6  as it is already aware of the S1 handover in progress. However, from implementation point of view, it looks better to pause after the setp #6 as it is a common place both for S1 and X2 handover.

If the timer at MME expires and the PDN connectivity couldn't be completed, it is expected that the UE reattempts the PDN connectivity procedure. In order to request connectivity to an additional PDN, the UE shall start timer T3482 after sending PDN connectivity request and enter the state of PROCEDURE TRANSACTION PENDING[TS24.301]. The T3482 stops when the UE receives the Activate default EPS bearer Context request or if expires, the UE reattempts the PDN connectivity procedure.

Red Mouse